Crossover Pipe- Toyota 3.4L 5VZ Federal Swap Crossover Exhaust Pipe (Drivers Side Drop) (1995-2001) Kit-1043
This exhaust crossover pipe is designed to be used when swapping a Toyota 3.4L 5VZ-FE Engine into a 1984-1995 Toyota Truck or 4Runner that has the exhaust on the drivers side. Crossover pipe flanges are 3/8". Crossover pipe has been powder coated black to protect pipe from rust and insure a long life. The Flanges are countersunk to use the same round factory style exhaust gaskets for a factory type seal. These crossover pipes are a direct bolt up to the factory 2:1 section with the 02 sensor mount. The down pipe is part # 17410-07070.
This 5VZ swap crossover exhaust pipe is designed to be used with the Toyota 3.4L 5VZ factory exhaust manifolds for 1995 -2001 with Federal Emissions. These are the cast manifolds, California emissions and 2002-2004 manifolds are non cast and have a different flange shape*. If you have these later manifolds you will need KIT-1043B The drivers side drop exhaust pipe has been designed to fit with the Toyota 3.0L 3VZ-E manual transmission bell-housing with the slave cylinder on the passenger side. It will also fit the automatic transmission bell-housing.
This pipe does not fit JDM engines! We have found that there are numerous JDM manifolds. We have not made a crossover pipe for any JDM manifolds. JDM engines are used engines imported into the US and were never sold in vehicles in the United States.
1 Drivers side drop exhaust crossover pipe
4 exhaust gaskets 90917-06065
3 exhaust studs 90116-10150
3 exhaust nuts 90080-17187
Other DetailsThis item is backed by a 12-month manufacturer warranty What is covered? • Manufacturing defects • Faults caused by improper workmanship or materials What is not covered? • Issues caused by heat wrap. • Any modifications made to pipe. • Time loss or incidental damage. • Improper installation. • failure to properly support exhaust causing undue stress or lack of hangers.
11 Reviews Hide Reviews Show Reviews
worked as designed.
Slight interference on rear solid rear heat lines on 4Runner only upon engine installation. No damage to truck or exhaust flange. Perfect fit upon final installation. Very happy.
Very good quality
Killer parts takes a little longer to get but that’s Covid problem yotashop supply’s the best for us do it your self hillbilly’s A+
I added self sticking firewall shielding to my stock 4runner. Plus I used 1 30/32 ID exhaust gaskets instead of the ones in the kit.
I tried to build my own crossover pipe, but it was time consuming and it wasn't looking like I wanted too. Do yourself a favor and just buy this. So much easier.
I originally tried to build my own cross over out of the factory one like I read about. Ended up hitting the frame. I bought this as a solution and it fits so perfectly in the narrow window for it to go. Great product.
This went on perfectly, effortlessly. Great product! Thank you!
Shipped faster than expected, fit perfect came with everything I needed and looks Great! Definitely recommend this product to anyone performing this swap,