5VZ Swap- Toyota 3.4L 5VZ-FE into 4Runner or Pickup Truck Engine Swap Install Kit (Kit-3030)
This kit provides you with the necessary parts to complete a 3.4L conversion.
- Vibrant Performance Open Funnel Air Filter
- 5VZ Side mount dipstick kit
- 5VZ Swap Crossover Exhaust Pipe (Drivers Side Drop)
- 10K RESISTOR FOR TACH
- 5VZ Swap Body Lift 3/8"
- 2 Toyota O2 Sensor Mounting Flange Kit
This exhaust crossover pipe is designed to be used when swapping a Toyota 3.4L 5VZ-FE Engine into a 1984-1995 Toyota Truck or 4Runner that has the exhaust on the drivers side. Crossover pipe flanges are 3/8". Crossover pipe has been high temp powder coated black to protect pipe from rust and insure a long life. This 5VZ swap crossover exhaust pipe is designed to be used with the Toyota 3.4L 5VZ factory exhaust manifolds for 1995 -2001 with Federal Emissions, these are the cast manifolds, California emissions and 2002-2004 manifolds are non cast and have a different flange shape*. If you have these later manifolds select the California & 2002-04 crossover pipe. These crossover pipes are a direct bolt up to the factory 2:1 section with the 02 sensor mount. The Flanges are countersunk to use the same round factory style exhaust gaskets for a factory type seal.. The drivers side drop exhaust pipe has been designed to fit with the Toyota 3.0L 3VZ-E manual transmission bell-housing with the slave cylinder on the passenger side. It will also fit the automatic transmission bell-housing.
Other DetailsThis item is backed by a 12-month manufacturer warranty What is covered? • Manufacturing defects • Faults caused by improper workmanship or materials What is not covered? • Issues caused by heat wrap. • Any modifications made to pipe. • Time loss or incidental damage. • Improper installation. • failure to properly support exhaust causing undue stress or lack of hangers.
1 Review Hide Reviews Show Reviews
Makes life a lot easier
This is all you could ask for when doing a 3.4 conversion.